Access server

A Network Access Server (NAS) is a single point of access to a remote resource.

Overview

Concentrates dial-in and dial-out user communications. An access server may have a mixture of analog and digital interfaces and support hundreds of simultaneous users.

Communications processor that connects asynchronous devices to a LAN or WAN through network and terminal emulation software. Performs both synchronous and asynchronous routing of supported protocols. Sometimes called a network access server (NAS).

The NAS is meant to act as a gateway to guard access to a protected resource. This can be anything from a telephone network, to printers, to the Internet.

The client connects to the NAS. The NAS then connects to another resource asking whether the client's supplied credentials are valid. Based on that answer the NAS then allows or disallows access to the protected resource.

Examples

The above translates into different implementations for different uses. Here are some examples.

  • An Internet Service Provider which provides network access via common modem or modem-like devices (be it PSTN, DSL, cable or GPRS/UMTS) can have one or more NAS (network access server) devices which accept PPP, PPPoE or PPTP connections, checking credentials and recording accounting data via back-end RADIUS servers, and allowing users access through that connection.
  • A sample use is the captive portal mechanism used by many WiFi providers: a user wants to access the Internet and opens a browser. The NAS detects that the user is not currently authorized to have access to the Internet, so the NAS prompts the user for their username and password. The user supplies them and sends them back to the NAS. The NAS then uses the RADIUS protocol to connect to an AAA server and passes off the username and password. The RADIUS server searches through its resources and finds that the credentials are valid and notifies the NAS that it should grant the access. The NAS then grants the user access to the internet.
  • Another use of a NAS would be in VoIP. However, instead of using a username and password, many times a phone number or IP Address are used. If the phone number is a valid customer then the call can be completed. Other uses might be if the phone number has long distance access or if a telephone card has minutes left.

Associated Protocols

Although not required, NASs are almost exclusively used with Authentication, Authorization, and Accounting (AAA) servers. Of the AAA protocols available, RADIUS tends to be the most widely used. The Diameter base protocol extends RADIUS services by providing error handling and inter-domain communications. This protocol is used in networks like the IP Multimedia Subsystem (IMS).

See also

This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
 
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
 
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.