World Library  
Flag as Inappropriate
Email this Article

Insertion loss

Article Id: WHEBN0000041266
Reproduction Date:

Title: Insertion loss  
Author: World Heritage Encyclopedia
Language: English
Subject: Loss, Roll-off, Analog passthrough, Return loss, Fusion splicing
Collection:
Publisher: World Heritage Encyclopedia
Publication
Date:
 

Insertion loss

In telecommunications, insertion loss is the loss of signal power resulting from the insertion of a device in a transmission line or optical fiber and is usually expressed in decibels (dB).

If the power transmitted to the load before insertion is PT and the power received by the load after insertion is PR, then the insertion loss in dB is given by,

10 \log_{10} {P_\mathrm T \over P_\mathrm R}

Electronic filters

Insertion loss is a figure of merit for an electronic filter and this data is generally specified with a filter. Insertion loss is defined as a ratio of the signal level in a test configuration without the filter installed (|V1|) to the signal level with the filter installed (|V2|). This ratio is described in dB by the following equation:

\mbox{Insertion loss (dB)} = 10 \log_{10} {\left|V_1\right|^2 \over \left|V_2\right|^2} = 20 \log_{10} {\left|V_1\right| \over \left|V_2\right|}

Note that, for most filters, |V2| will be smaller than |V1|. In this case, the insertion loss is positive and measures how much smaller the signal is after adding the filter.

Link with Scattering parameters

In case the two measurement ports use the same reference impedance, the insertion loss (IL) is defined as:[1][2]

IL = -20\log_{10}\left|S_{21}\right| \,\text{dB}

and not, as often mistakenly thought, by:

IL = 10\log_{10}\frac{\left|S_{21}\right|^2}{1-\left|S_{11}\right|^2}\, dB.

Here S_{11} and S_{21} are two of the scattering parameters. It is the extra loss produced by the introduction of the DUT between the 2 reference planes of the measurement. The extra loss can be introduced by intrinsic loss in the DUT and/or mismatch. In case of extra loss the insertion loss is defined to be positive.

See also

References

  1. ^ Pozar, David M.; Microwave Engineering, Third Edition
  2. ^ Collin, Robert E.; Foundations For Microwave Engineering, Second Edition
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
 
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
 
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.
 



Copyright © World Library Foundation. All rights reserved. eBooks from Hawaii eBook Library are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.